Solar Powered & Cost Effective
Traffic Control Solutions

Home Page Products Capabilities Key People Dealer Network Contact & Inquiry
 

  
Trafictec SCC Power Board


Drives up to 12 traffic signal lamp circuits (4 phases). One or two
SSC Power Boards can be driven by a SBC-2400 traffic controller.

General

The SSC Power Board (made by Trafictec) provides the AC power needed to drive up to 12 separate traffic signal lamp circuits (4 phases). It is ideal for use with the SBC-2400 Traffic Controller CPU, but can also be used with other traffic controllers. Two SSC Power Boards may be connected to a SBC-2400 Traffic Controller CPU to control up to 24 traffic signal lamp circuits (8 phases).

The SSC Power Board converts the logic level signals it receives from the traffic controller to 110 or 220 VAC outputs to drive lamp circuits. All AC inputs and outputs are fused separately. The power board also has a separate output and a fuse for an external fan. Power for the SSC Power Board is provided by an off-the-shelf, regulated 12 VDC power supply capable of at least 15 Watts (available as an accessory).

Two field-wiring connectors are located at the lower edge of the SSC Power Board and are detachable, with a female “header” soldered to the PCB and a mating removable male “plug,” which acts as the terminal block for the field wires. Detachable connectors simplify board replacement because the individual field wires do not have to be disconnected from the terminal block.

Theory of Operation

The Trafictec SSC Power Board has 12 signal lines that are connected to the controller CPU board via a 20-pin IDE connector on the right edge of the power board. Each signal line corresponds to one of the 12 lamp outputs and is protected by a dedicated fuse. There are 4 phases per power board, each with a red, yellow and green output. When the traffic controller grounds a signal line to the power board, an opto-coupler turns on a triac, which completes the lamp circuit. Mounted next to each of the 12 opto-couplers is a red, yellow or green LED, which turns on when the triac for that phase is on. The LEDs aid the technician when troubleshooting problems.

The Power Board design also includes a fuse monitor circuit, which monitors the 4 fuses used to protect the “red” outputs. If this circuit detects that one of these 4 fuses has blown, it grounds a signal line that is connected to the traffic controller. If the controller detects that this line has gone low, its software will put the intersection in flash or take some other action based on the failure notification.

SBC-2400 Traffic Control Assembly with SBC-2400 CPU Board (top) and two SSC Power Driver Boards (below) to handle up 24 signal heads. The CPU Board is hinged to provide access to terminal blocks, fuses and LED indicators.

Product Specs

 Working temperature  -20°C to +75°C
 Input power  +12 VDC @ 100 mA max plus 110 or 220 VAC line
 Output power  12 VDC, 24 VDC, 110 VAC or 220 VAC, factory configured
 Indicators  12 LEDs, one to monitor status of each output.
 Isolation  Optical couplers rated 5 kV
 Triac rating  600V, 12A
 Mating connectors  20-pin IDE male for interconnect to CPU board.
 6 and 12-pole, two-part terminal blocks for field wiring,
 15A / pole for wire size 12-20 AWG.
 Fan output voltage  Same as line voltage (110 or 220 VAC)

Input Connector Pin Assignments
(IDE 20 pin male connector)

1 Red phase 1 11 Green phase 2
2 Red phase 4 12 Fuse monitor for phase 3 Red
3 Yellow phase 1 13 Red phase 3
4 Yellow phase 4 14 Fuse monitor for phase 4 Red
5 Green phase 1 15 Yellow phase 3
6 Green phase 4 16 +12 VDC
7 Red phase 2 17 Green phase 3
8 Fuse monitor for phase 1 Red 18 +12 VDC
9 Yellow phase 2 19 Ground
10 Fuse monitor for phase 2 Red 20 Ground

 

SBC-2400 Single Board Controller System

 SBC-2400 Controller CPU
 SBC-2400 Traffic Software
 Software Manual
 HHT Programming Unit
 SBC-2400 Test Equipment
 SSC Power Board
 CMU Conflict Monitor Unit
 Cabinet Power Supply
 Loop Detectors
 Traffic Cabinets
  
  

Zwiesler Resources Inc. Capabilities

 Solar Power for Traffic
 Zwiesler Home Page
 Contact ZRI
 
  

Cost-Effective Traffic Control Solutions
for International Markets

Tel:  760-943-8675
Fax: 760-943-8675

220 Via del Cerrito
Encinitas, CA 92024, USA

 
www.zwiesler.com

© 2008 Zwiesler Resources, Inc.. All rights reserved.

home4.jpg (3210 bytes)